Richmond Hill Drywall Contractor for Installation & Repair

We cover all of Richmond Hill, including Oak Ridges, Richvale, Crosby, Bayview Hills, Jefferson, Devonsleigh, Rouge Woods, Headford, and the Yonge Street corridor, plus neighbouring Vaughan and Markham. Most Richmond Hill jobs are scheduled within 1-2 days of the free on-site estimate.

In 2026, standard drywall installation in Richmond Hill runs $2.50 to $5.00 per square foot installed and finished at Level 4. Level 5 skim coat adds 25 to 40 percent above the Level 4 price. A typical Bayview Hills basement (700 to 1,000 sq ft) runs $5,000 to $14,000 for full drywall including framing and moisture-resistant panels, and every free on-site estimate comes with line-item pricing.

A typical 800 to 1,200 sq ft Richmond Hill basement takes 7 to 14 working days from framing through a Level 4, paint-ready finish. Bulkheads around ductwork, ceiling drywall, and the City of Richmond Hill framing and insulation inspections are the main factors that move the timeline.

Yes, for any Richmond Hill home built before 1980. Oak Ridges, Richvale, and Crosby properties built between 1960 and 1980 frequently have acoustic spray texture with positive asbestos results. We coordinate certified air or bulk sampling and route to a licensed abatement contractor where required before dustless removal starts.

Level 4 is the standard residential finish: joints and fasteners covered with three coats of compound, smooth and paint-ready under matte and eggshell paints. Level 5 adds a full skim coat over the entire panel surface and is standard on Bayview Hills and Jefferson custom builds with tall windows, glossy paints, or raking light. We sand Level 5 walls flat and do a raked-light walk-through before handover.

Damage under about 12 by 12 inches on a solid panel gets patched, while larger holes or board that is soft from water or crumbling from impact gets cut back to the nearest studs and replaced. In Richvale and Crosby homes, cracks that keep returning at door and window corners are settling cracks, so the movement is assessed before the joint is retaped.

For Richmond Hill basements we use moisture-resistant Green Board on all below-grade exterior walls and Purple Board in bathroom wet areas. Steel-stud framing is set away from the foundation wall with a drainage gap, and a 6-mil poly vapour barrier is installed across the interior face before drywall goes up. Standard 1/2-inch panels are used on interior partitions above the slab.

Yes, in most cases. The City of Richmond Hill requires a building permit under the Ontario Building Code for basement finishing that includes new walls, electrical, plumbing, or creation of a secondary suite. The permit triggers framing, insulation, rough-in mechanical, and final occupancy inspections, and we coordinate inspection timing with our installation schedule.

Most construction contractors in Ontario must register with WSIB, and homeowners should ask for a WSIB clearance certificate and proof of liability insurance before work starts. Toronto Drywall Pro is licensed, bonded, WSIB-compliant, and carries $2M in liability insurance, with documents available for every Richmond Hill project.

Yes. We use HEPA-filtered dustless sanding, floor protection along every traffic path, and plastic containment at doorways so the rest of the home stays liveable. You get a daily schedule showing which rooms are active each day.

Home theatre acoustic drywall assemblies in Richmond Hill custom homes typically target STC 58 to 65. We design the assembly to match the STC target, seal every penetration and outlet box with acoustic sealant, and can arrange post-install sound measurement where STC verification is contractually required.